Was just curious how everybody celebrates and how you will incorporate your Benny into your 4th of July plans.
Do you decorate your Benny with flags, banners, etc? You got some special foods, snacks and drinks you are taking out? Maybe you an share a favorite recipe. If left up to me, I will...
Never heard of dino oil and I searched in this forum, up one side and down the other in Hulltruth.com and in floridasportsman.com about Yamaha 150s. Can you tell me more about it?
gotta say I really do love this forum...the help, advice and ideas are always so awesome...don't get the same...
My documentation says to change the engine oil & filter and change the lower unit oil, grease your fittings and inspect your anodes, wiring, etc
My dealer just quoted me $440! Took them 4 days to respond at that and I asked them what all do I get for $440 and I still haven't gotten a response...
I concur...you really do want to run separate positive and negative cables directly to the amp...I think the minimum recommended was 16 AWG but I was already using 12 AWG for other stuff so that is what I used. The stereo harness wires are either 18 or 22 AWG..pretty small..however, you will...
The install instructions say to put the inline fuses but they almost have to because they don't know how long your runs will be between the ACR and the battery, how you are running, etc...I consulted with some other people and a guy who contacted blue seas directly and blue seas said that no...
Poor quality scan of my original diagram but this should give you a basic idea of how I connected everything. I tried to note on the diagram the wire gauges I used and the size lugs that needed to be on each individual cable. Used 4 AWG everywhere except from the ACR to the both batteries -...
I just confirmed it is the yellow wire from the manual. The yellow should go directly to the battery from the harness and the red should go to the rocker switch; however, just as someone mentioned if you have a battery switch if you turn that off it doesn't matter because you disconnect all...
haha..thanks but actually it was my first go at something like that...the Bennington forum is great so with everyones help and some of my own research I devised my own plan that worked for me...I basically took bits and pieces of what other guys already tried and tested, and I made it my own...
I did consider the powered subwoofer just because it seemed simpler to run power and speakers to done device and be done with it; however, I decided to go the route that PDXHosedragger went withthe separate amb and passive subwoofer...I didnt want to build a sub box so I got the bazooka powered...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.