Electrical Specs - Look here first for schematics

  • Thread starter Retired Team Member1
  • Start date

cwag911

Moderator
Messages
5,995
Reaction score
2,107
Location
Denver, NC on beautiful Lake Norman
You might want to send an email to Bennington for the diagram.
 

lakeliving

Well-Known Member
Messages
7,859
Reaction score
5,595
Location
Michigander living In Palm City FL
I thought these came with the boat when you buy one??? No. I could swear I have one in my paperwork.
 

Bob K

New Member
Messages
2
Reaction score
0
I am looking for a schematic for a 2009 2275 GLI. How best to procede? Just bought my first benny used and wiringh has been modded by a hack.
 

Link

Moderator
Messages
5,053
Reaction score
2,427
Location
Sacandaga Lake, NY
I am looking for a schematic for a 2009 2275 GLI. How best to procede? Just bought my first benny used and wiringh has been modded by a hack.
On the first page of this thread, the first post. Don't click on the underlined GRQ instead click on the attached file link below it
 

Bob K

New Member
Messages
2
Reaction score
0
So i want the grq schematic, you just asking me to click on the grq in the box?
 

FADEC

New Member
Messages
1
Reaction score
0
Would anybody have a schematic for a 2011 2575 qcw i/o? My paperwork included a schematic for an outboard powered boat, my boat has a few extra accessories like a powered rear deck/engine cover and compartment blower, etc...
 

Hotwings

New Member
Messages
2
Reaction score
0
Hello,

Sorry in advance if I’m in the wrong forum. Can someone tell me how I can change a starboard nav light bulb on a 2012 20 SL? The port and and anchor light work fine. Thanks in advance.
 

JohnL

Active Member
Messages
36
Reaction score
38
Location
Delaware
It’s pretty easy you just have to take the plastic mounting frame apart to get the nav light out. Open the nav light and replace the bulb. Once I had the nav light out and apart, I threw the old one away and put a new LED nav light in. (The holes don’t line up with the new one, but that was easily fixed) Now I shouldn’t have to worry about changing that bulb ever again. Bought the other side and will do the same with that when that bulb burns out or I get energetic next spring when I prep the boat.
 

ArtJ

Member
Messages
23
Reaction score
4
Location
Lake Oconee, Georgia
Schematics for the DIY members!

S Series schematic REVISED 9-2-12. Thanks Semperfi!!

G.R.Q elec.pdf

Sseries2013schematicREV.pdf
On drawing no. 4066 of "S Series Outboards 2013 model" pink wire from fuel sender is shown as not only connected to one terminal on the fuel gauge but also connected (along with a blue wire) to the other terminal marked "gauge light". I believe only the blue wire should be connected to this second terminal.
 
Top